How to change engine / coolant temperature sensor on VW group engines (VW/Audi/SEAT/Skoda) Golf mk4 generation. Car shown is 1.8t Skoda Octavia vRS, same par

Code: 10382 - Coolant Circulation Valve (N214) P1257 00 [096] - Open Circuit Intermittent - Not Confirmed - Tested Since Memory Clear Freeze Frame: Fault Status: 00000001 Fault Priority: 2 Fault Frequency: 4 Mileage: 252040 km Date: 2023.06.25 Time: 18:56:14 Engine RPM: 1713.00 /min Normed load value: 62.4 % Vehicle speed: 74 km/h Coolant
Here are a couple optional items that are just much easier to do "while you're in there": #6: Replace and/or reseal the oil filter housing and thermostat housing. New units include a new thermostat. #7: Replace the water pump and bolts (if aluminum). Last edited by -Wes-; 01-23-2023 at 10:48 AM. Reply Like.
Coolant Temperature Sensor Car 06k919525 079919525c For Audi A6 A7 A8 Q3 Q5 Tt For Vw Jetta Mk6 , Find Complete Details about Coolant Temperature Sensor Car 06k919525 079919525c For Audi A6 A7 A8 Q3 Q5 Tt For Vw Jetta Mk6,Coolant Temperature Sensor For Audi,06k919525 Engine Coolant Temperature Sensor,Vw Coolant Temperature Sensor from Other Auto Engine Parts Supplier or Manufacturer-Yiwu
Cold air starts coming out of the passenger side vent then all the other vents and the engine oil temps starts climbing up about 20-25 degrees more than the normal. The coolant temp is kind of stuck at 190, which I saw at an earlier post above. I slow down to 45mph and the oil temp drops down to the normal range. Drop off vehicle again.
Re: Coolant temp sensor location on 3.0? It's located in the top rear edge of the engine. Close to the firewall slightly to the passenger side. It is plumbed into a black metal pipe (coolant distribution pipe) and has a circlip that holds it into a recessed socket. The harness is a 4-pin. Step 2 – Install new O2 sensor. Make sure that you have the correct type of sensor. Applying a small amount of anti-seize grease will make the O2 sensor easier to remove in the future. Thread in the new O2 sensor by hand, then tighten it with a ratchet. Then reconnect the electrical connector. Sensor locations denoted to assist in correct location, installation and connections. 1. Technical Tips. 9 - Exhaust Gas Temperature Sensor 1 -G235- 059 906 088 BJ (Black) 19 - Exhaust Gas Temperature Sensor 2 -G448- 059 906 088 BS (Black) 18 - Exhaust Gas Temperature Sensor 3 -G495- 059 906 088 BP (Brown) 10 - Exhaust Gas Temperature Sensor 4
Coolant leak issue. I recently purchased a 2013 Audi TDI 3.0L. I saw pool of liquid below it and determined it was antifreeze. I got a low level alarm on next start up to move up to garage. Once I popped the hood noticed coolant everywhere as it was thrown around by the belt and pulley's. I pressurized the system and nothing would leak.
jJr9zD.
  • jrn43x7eiu.pages.dev/930
  • jrn43x7eiu.pages.dev/361
  • jrn43x7eiu.pages.dev/85
  • jrn43x7eiu.pages.dev/413
  • jrn43x7eiu.pages.dev/757
  • jrn43x7eiu.pages.dev/916
  • jrn43x7eiu.pages.dev/413
  • jrn43x7eiu.pages.dev/774
  • jrn43x7eiu.pages.dev/379
  • jrn43x7eiu.pages.dev/342
  • jrn43x7eiu.pages.dev/615
  • jrn43x7eiu.pages.dev/888
  • jrn43x7eiu.pages.dev/61
  • jrn43x7eiu.pages.dev/422
  • jrn43x7eiu.pages.dev/405

    • audi q7 3.0 tdi coolant temperature sensor location